GT series｜Machine Tool Products

Machine Tool

High clamping torque NC rotary table
GT series

NC rotary table suitable for heavy machining
The very strong clamping torque was achieved by increased piston area and new clamping mechanism.
High clamping torque and rigid body allows heavy machining and shorter tact time.
Built-in rotary joint available

*CE correspondence

Model			GT200	GT250	GT320
Table Diameter (mm)			200	250	320
Register Diameter of Face Plate (mm)			65H7	100H7	130H7
Spindle Through-Hole Diameter (mm)			45	70	105
Centre Height (mm)			140	180	225
Clamping Torque (N･m) at Pneumatic 0.5 MPa			820	1600	2800
Inertia Converted into Motor Shaft (kg･m²)			0.00023	0.00036	0.00039
Gear Ratio			1/72	1/90	1/120
Max. Spindle Speed (min^-1)			41.6 (motor 3000min^-1)	33.3 (motor 3000min^-1)	16.6 (motor 2000min^-1)
Allowable Work Inertia (kg･m²)			1.00	1.95	4.49
Indexing Accuracy (sec)			20	20	20
Repeatability (sec)			4	4	4
Mass of Product (kg)			65	87	145
Allowable Load		Horizontal (kg)	200	250	350
Allowable Load		Vertical (kg)	100	125	180
Manual Tailstock (as an option)			MR200RN	MR250RN	MR320RN
Tail Spindle (as an option)			MSR142A/TSR142A	MSR181A/TSR181A	TSR181A45
Rotary joint (as an option)			RJ40H20J01 Hydraulic/Pneumatic 4 ports	RJ70H25J01 Hydraulic/Pneumatic 6 ports	RJ70H32J01 Hydraulic/Pneumatic 6 ports
Outline Drawing	Kitagawa Own Controller Spec.	2D



		3D
		3D
	Additional axis (FANUC spec.)	3D
	Additional axis (FANUC spec.)	3D
Option Outline Drawing			Tailstock \| Tail Spindle